Modem act as a bridge, and just passes packets across the DSL port. Connect the Ethernet cable if you have not done so. Check if the modem is powered on and make sure the Status light on the modem is flashing. In the window as shown above, enter your name and company information and click on Next. To configure the WAN connection for Static, perform the steps listed below.

Uploader: Dourr
Date Added: 12 October 2007
File Size: 65.52 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 38588
Price: Free* [*Free Regsitration Required]

This state of the uusb modem will deliver you flexible connectivity to your Internet Service Provider and allow you to connect to the Internet via your broadband ADSL connection.

Configuring the modem 3. Update Gateway Use the Update Gateway feature to load the latest firmware for the device.

Double-click on your Local Area Connection and select Support tab. Reinstall the software as shown through points 1. Connect the ADSL cable if you have not done so.

A list of D-Link offices is provided at the back of this manual, together with a copy of the Registration Card. Page 65 Le Florilege, No.

D-Link DSL T – DSL modem Overview – CNET

The Modem is easy to install and use. If desired, change the Idle Timeout value. If you wish to reserve the uplink port on the switch or hub for another device, connect to any on the other MDI-X ports 1x, 2x, etc.

  CRAFT ROBO LITE CC300-20 DRIVER

Connecting modem to PC If you have not done so, connect power cable to the modem. Subnet Mask The bits of the subnet mask correspond directly to the bits of the IP address. The diagram below illustrates the proper use of the splitter. The Modem may be reset to its factory default settings by performing a Restore settings operation within the management interface see below.

A solid green light indicates a valid link on startup.

D-Link DSL-302T User Manual

Tabs across the top of the screen show other available menus: To Ping a device, first enter the IP address of the device that you wish to Ping into the first field, the Packet Size in bytes in the second field, and finally, enter the number of times you wish the Ping function to attempt a connection to the desired device into the third field. Enter text from picture: Status — System Log window Click Refresh to get the most current system log information.

Opening Status window Click the hyperlink for the desired Status window. These devices are commonly referred to as microfilters or sometimes called inaccurately line splitters.

  HP SSL1016 DRIVER DOWNLOAD

Page 11 ADSL connection in the future. The Ethernet Diagnostics software can be used to monitor the device. Got it, continue to print. Connect the Ethernet cable if you have not done so.

D-Link DSL 302T – DSL modem

Standards Compatibility and Compliance The DSLT complies with or is compatible with the following standards as recognized by their respective agencies. Introduction The Modem is easy to install and use.

Table of Contents Dls-302t to my manuals Add. After a few seconds the new connection you just configured will become the active connection for the Modem. Page of 69 Go.

Download driver usb d link dsl t

Look for a device which is not installed correctly and has yellow question mark or exclamation point next to it. Place the Modem in a location where it can be connected to the various devices as well as to a power source. Select Static from the Type: Follow the instructions to install the files.

Check your WEB browser settings: